vmxnet3: ensure that adapter is in proper state during force_close

There are several paths in vmxnet3, where settings changes cause the
adapter to be brought down and back up (vmxnet3_set_ringparam among
them). Should part of the reset operation fail, these paths call
vmxnet3_force_close, which enables all napi instances prior to calling
dev_close (with the expectation that vmxnet3_close will then properly
disable them again). However, vmxnet3_force_close neglects to clear
VMXNET3_STATE_BIT_QUIESCED prior to calling dev_close. As a result
vmxnet3_quiesce_dev (called from vmxnet3_close), returns early, and
leaves all the napi instances in a enabled state while the device itself
is closed. If a device in this state is activated again, napi_enable
will be called on already enabled napi_instances, leading to a BUG halt.

The fix is to simply enausre that the QUIESCED bit is cleared in
vmxnet3_force_close to allow quesence to be completed properly on close.

Signed-off-by: Neil Horman <[e-mail]>
CC: Shrikrishna Khare <[e-mail]>
CC: "VMware, Inc." <[e-mail]>
CC: "David S. Miller" <[e-mail]>
Signed-off-by: David S. Miller <[e-mail]>

drivers/net/vmxnet3/vmxnet3_drv.c

···
 	/* we need to enable NAPI, otherwise dev_close will deadlock */
 	for (i = 0; i < adapter->num_rx_queues; i++)
 		napi_enable(&adapter->rx_queue[i].napi);
+	/*
+	 * Need to clear the quiesce bit to ensure that vmxnet3_close
+	 * can quiesce the device properly
+	 */
+	clear_bit(VMXNET3_STATE_BIT_QUIESCED, &adapter->state);
 	dev_close(adapter->netdev);
 }