Pull Kbuild fixes from Masahiro Yamada:

- Clear errno before calling getline()

- Fix a modpost warning for ARCH=alpha

* tag 'kbuild-fixes-v6.5-2' of git://git.kernel.org/pub/scm/linux/kernel/git/masahiroy/linux-kbuild:
alpha: remove __init annotation from exported page_is_ram()
scripts/kallsyms: Fix build failure by setting errno before calling getline()

Pull x86 platform drivers fixes from Hans de Goede:

- lenovo-ymc driver causes keyboard + touchpad to not work with >= 6.4
on some Thinkbook models, fix this

- A set of small fixes for mlx-platform

- Other small fixes and hw-id additions

* tag 'platform-drivers-x86-v6.5-4' of git://git.kernel.org/pub/scm/linux/kernel/git/pdx86/platform-drivers-x86:
platform/x86: lenovo-ymc: Only bind on machines with a convertible DMI chassis-type
platform: mellanox: Change register offset addresses
platform: mellanox: mlx-platform: Modify graceful shutdown callback and power down mask
platform: mellanox: mlx-platform: Fix signals polarity and latch mask
platform: mellanox: Fix order in exit flow
platform/x86: ISST: Reduce noise for missing numa information in logs
platform/x86: msi-ec: Fix the build
ACPI: scan: Create platform device for CS35L56
platform/x86/amd/pmf: Fix unsigned comparison with less than zero

EXPORT_SYMBOL and __init is a bad combination because the .init.text
section is freed up after the initialization.

Commit c5a130325f13 ("ACPI/APEI: Add parameter check before error
injection") exported page_is_ram(), hence the __init annotation should
be removed.

This fixes the modpost warning in ARCH=alpha builds:

WARNING: modpost: vmlinux: page_is_ram: EXPORT_SYMBOL used for init symbol. Remove __init or EXPORT_SYMBOL.

Fixes: c5a130325f13 ("ACPI/APEI: Add parameter check before error injection")
Signed-off-by: Masahiro Yamada <masahiroy@kernel.org>
Reviewed-by: Randy Dunlap <rdunlap@infradead.org>

Pull SCSI fixes from James Bottomley:
"Eleven small fixes, ten in drivers.

Of the two fixes marked core, one is in the raid helper class (used by
some raid device drivers) and the other one is the /proc/scsi/scsi
parsing fix for potential reads beyond the end of the buffer"

* tag 'scsi-fixes' of git://git.kernel.org/pub/scm/linux/kernel/git/jejb/scsi:
scsi: qedf: Fix firmware halt over suspend and resume
scsi: qedi: Fix firmware halt over suspend and resume
scsi: qedi: Fix potential deadlock on &qedi_percpu->p_work_lock
scsi: lpfc: Remove reftag check in DIF paths
scsi: ufs: renesas: Fix private allocation
scsi: snic: Fix possible memory leak if device_add() fails
scsi: core: Fix possible memory leak if device_add() fails
scsi: core: Fix legacy /proc parsing buffer overflow
scsi: 53c700: Check that command slot is not NULL
scsi: fnic: Replace return codes in fnic_clean_pending_aborts()
scsi: storvsc: Fix handling of virtual Fibre Channel timeouts

The lenovo-ymc driver is causing the keyboard + touchpad to stop working
on some regular laptop models such as the Lenovo ThinkBook 13s G2 ITL 20V9.

The problem is that there are YMC WMI GUID methods in the ACPI tables
of these laptops, despite them not being Yogas and lenovo-ymc loading
causes libinput to see a SW_TABLET_MODE switch with state 1.

This in turn causes libinput to ignore events from the builtin keyboard
and touchpad, since it filters those out for a Yoga in tablet mode.

Similar issues with false-positive SW_TABLET_MODE=1 reporting have
been seen with the intel-hid driver.

Copy the intel-hid driver approach to fix this and only bind to the WMI
device on machines where the DMI chassis-type indicates the machine
is a convertible.

Add a 'force' module parameter to allow overriding the chassis-type check
so that users can easily test if the YMC interface works on models which
report an unexpected chassis-type.

Fixes: e82882cdd241 ("platform/x86: Add driver for Yoga Tablet Mode switch")
Link: https://bugzilla.redhat.com/show_bug.cgi?id=2229373
Cc: André Apitzsch <git@apitzsch.eu>
Cc: stable@vger.kernel.org
Tested-by: Andrew Kallmeyer <kallmeyeras@gmail.com>
Tested-by: Gergő Köteles <soyer@irl.hu>
Signed-off-by: Hans de Goede <hdegoede@redhat.com>
Link: https://lore.kernel.org/r/20230812144818.383230-1-hdegoede@redhat.com

getline() returns -1 at EOF as well as on error. It also doesn't set
errno to 0 on success, so initialize it to 0 before using errno to check
for an error condition. See the paragraph here [1]:

For some system calls and library functions (e.g., getpriority(2)),
-1 is a valid return on success. In such cases, a successful return
can be distinguished from an error return by setting errno to zero
before the call, and then, if the call returns a status that indicates
that an error may have occurred, checking to see if errno has a
nonzero value.

Bear has a bug [2] that launches processes with errno set and causes the
following build failure:

$ bear -- make LLVM=1
...
LD .tmp_vmlinux.kallsyms1
NM .tmp_vmlinux.kallsyms1.syms
KSYMS .tmp_vmlinux.kallsyms1.S
read_symbol: Invalid argument

[1]: https://linux.die.net/man/3/errno
[2]: https://github.com/rizsotto/Bear/issues/469

Fixes: 1c975da56a6f ("scripts/kallsyms: remove KSYM_NAME_LEN_BUFFER")
Reviewed-by: Miguel Ojeda <ojeda@kernel.org>
Signed-off-by: James Clark <james.clark@arm.com>
Signed-off-by: Masahiro Yamada <masahiroy@kernel.org>

Pull btrfs fixes from David Sterba:
"More fixes, some of them going back to older releases and there are
fixes for hangs in stress tests regarding space caching:

- fixes and progress tracking for hangs in free space caching, found
by test generic/475

- writeback fixes, write pages in integrity mode and skip writing
pages that have been written meanwhile

- properly clear end of extent range after an error

- relocation fixes:
- fix race betwen qgroup tree creation and relocation
- detect and report invalid reloc roots"

* tag 'for-6.5-rc5-tag' of git://git.kernel.org/pub/scm/linux/kernel/git/kdave/linux:
btrfs: set cache_block_group_error if we find an error
btrfs: reject invalid reloc tree root keys with stack dump
btrfs: exit gracefully if reloc roots don't match
btrfs: avoid race between qgroup tree creation and relocation
btrfs: properly clear end of the unreserved range in cow_file_range
btrfs: don't wait for writeback on clean pages in extent_write_cache_pages
btrfs: don't stop integrity writeback too early
btrfs: wait for actual caching progress during allocation

While performing certain power-off sequences, PCI drivers are called to
suspend and resume their underlying devices through PCI PM (power
management) interface. However the hardware does not support PCI PM
suspend/resume operations so system wide suspend/resume leads to bad MFW
(management firmware) state which causes various follow-up errors in driver
when communicating with the device/firmware.

To fix this driver implements PCI PM suspend handler to indicate
unsupported operation to the PCI subsystem explicitly, thus avoiding system
to go into suspended/standby mode.

Fixes: 61d8658b4a43 ("scsi: qedf: Add QLogic FastLinQ offload FCoE driver framework.")
Signed-off-by: Saurav Kashyap <skashyap@marvell.com>
Signed-off-by: Nilesh Javali <njavali@marvell.com>
Link: https://lore.kernel.org/r/20230807093725.46829-1-njavali@marvell.com
Signed-off-by: Martin K. Petersen <martin.petersen@oracle.com>

Move debug register offsets to different location due to hardware changes.

Fixes: dd635e33b5c9 ("platform: mellanox: Introduce support of new Nvidia L1 switch")
Signed-off-by: Vadim Pasternak <vadimp@nvidia.com>
Reviewed-by: Michael Shych <michaelsh@nvidia.com>
Link: https://lore.kernel.org/r/20230813083735.39090-5-vadimp@nvidia.com
Signed-off-by: Hans de Goede <hdegoede@redhat.com>

Pull gpio fixes from Bartosz Golaszewski:

- mark virtual chips exposed by gpio-sim as ones that can sleep
(callbacks must not be called from interrupt context)

- fix an off-by-one error in gpio-ws16c48

* tag 'gpio-fixes-for-v6.5-rc6' of git://git.kernel.org/pub/scm/linux/kernel/git/brgl/linux:
gpio: ws16c48: Fix off-by-one error in WS16C48 resource region extent
gpio: sim: mark the GPIO chip as a one that can sleep

We set cache_block_group_error if btrfs_cache_block_group() returns an
error, this is because we could end up not finding space to allocate and
mistakenly return -ENOSPC, and which could then abort the transaction
with the incorrect errno, and in the case of ENOSPC result in a
WARN_ON() that will trip up tests like generic/475.

However there's the case where multiple threads can be racing, one
thread gets the proper error, and the other thread doesn't actually call
btrfs_cache_block_group(), it instead sees ->cached ==
BTRFS_CACHE_ERROR. Again the result is the same, we fail to allocate
our space and return -ENOSPC. Instead we need to set
cache_block_group_error to -EIO in this case to make sure that if we do
not make our allocation we get the appropriate error returned back to
the caller.

CC: stable@vger.kernel.org # 4.14+
Signed-off-by: Josef Bacik <josef@toxicpanda.com>
Signed-off-by: David Sterba <dsterba@suse.com>

While performing certain power-off sequences, PCI drivers are called to
suspend and resume their underlying devices through PCI PM (power
management) interface. However the hardware does not support PCI PM
suspend/resume operations so system wide suspend/resume leads to bad MFW
(management firmware) state which causes various follow-up errors in driver
when communicating with the device/firmware.

To fix this driver implements PCI PM suspend handler to indicate
unsupported operation to the PCI subsystem explicitly, thus avoiding system
to go into suspended/standby mode.

Fixes: ace7f46ba5fd ("scsi: qedi: Add QLogic FastLinQ offload iSCSI driver framework.")
Signed-off-by: Nilesh Javali <njavali@marvell.com>
Link: https://lore.kernel.org/r/20230807093725.46829-2-njavali@marvell.com
Signed-off-by: Martin K. Petersen <martin.petersen@oracle.com>

Use kernel_power_off() instead of kernel_halt() to pass through
machine_power_off() -> pm_power_off(), otherwise axillary power does
not go off.

Change "power down" bitmask.

Fixes: dd635e33b5c9 ("platform: mellanox: Introduce support of new Nvidia L1 switch")
Signed-off-by: Vadim Pasternak <vadimp@nvidia.com>
Reviewed-by: Michael Shych <michaelsh@nvidia.com>
Link: https://lore.kernel.org/r/20230813083735.39090-4-vadimp@nvidia.com
Signed-off-by: Hans de Goede <hdegoede@redhat.com>

Pull tracing fixes from Steven Rostedt:

- Swapping the ring buffer for snapshotting (for things like irqsoff)
can crash if the ring buffer is being resized. Disable swapping when
this happens. The missed swap will be reported to the tracer

- Report error if the histogram fails to be created due to an error in
adding a histogram variable, in event_hist_trigger_parse()

- Remove unused declaration of tracing_map_set_field_descr()

* tag 'trace-v6.5-rc2' of git://git.kernel.org/pub/scm/linux/kernel/git/trace/linux-trace:
tracing/histograms: Return an error if we fail to add histogram to hist_vars list
ring-buffer: Do not swap cpu_buffer during resize process
tracing: Remove unused extern declaration tracing_map_set_field_descr()