Pull IOMMU fix from Joerg Roedel:
"Another fix, this time in common IOMMU sysfs code.

In the conversion from the old iommu sysfs-code to the
iommu_device_register interface, I missed to update the release path
for the struct device associated with an IOMMU. It freed the 'struct
device', which was a pointer before, but is now embedded in another
struct.

Freeing from the middle of allocated memory had all kinds of nasty
side effects when an IOMMU was unplugged. Unfortunatly nobody
unplugged and IOMMU until now, so this was not discovered earlier. The
fix is to make the 'struct device' a pointer again"

* tag 'iommu-fixes-v4.13-rc6' of git://git.kernel.org/pub/scm/linux/kernel/git/joro/iommu:
iommu: Fix wrong freeing of iommu_device->dev

Pull char/misc fix from Greg KH:
"Here is a single misc driver fix for 4.13-rc7. It resolves a reported
problem in the Android binder driver due to previous patches in
4.13-rc.

It's been in linux-next with no reported issues"

* tag 'char-misc-4.13-rc7' of git://git.kernel.org/pub/scm/linux/kernel/git/gregkh/char-misc:
ANDROID: binder: fix proc->tsk check.

The struct iommu_device has a 'struct device' embedded into
it, not as a pointer, but the whole struct. In the
conversion of the iommu drivers to use struct iommu_device
it was forgotten that the relase function for that struct
device simply calls kfree() on the pointer.

This frees memory that was never allocated and causes memory
corruption.

To fix this issue, use a pointer to struct device instead of
embedding the whole struct. This needs some updates in the
iommu sysfs code as well as the Intel VT-d and AMD IOMMU
driver.

Reported-by: Sebastian Ott <sebott@linux.vnet.ibm.com>
Fixes: 39ab9555c241 ('iommu: Add sysfs bindings for struct iommu_device')
Cc: stable@vger.kernel.org # >= v4.11
Signed-off-by: Joerg Roedel <jroedel@suse.de>

Pull staging/iio fixes from Greg KH:
"Here are few small staging driver fixes, and some more IIO driver
fixes for 4.13-rc7. Nothing major, just resolutions for some reported
problems.

All of these have been in linux-next with no reported problems"

* tag 'staging-4.13-rc7' of git://git.kernel.org/pub/scm/linux/kernel/git/gregkh/staging:
iio: magnetometer: st_magn: remove ihl property for LSM303AGR
iio: magnetometer: st_magn: fix status register address for LSM303AGR
iio: hid-sensor-trigger: Fix the race with user space powering up sensors
iio: trigger: stm32-timer: fix get trigger mode
iio: imu: adis16480: Fix acceleration scale factor for adis16480
PATCH] iio: Fix some documentation warnings
staging: rtl8188eu: add RNX-N150NUB support
Revert "staging: fsl-mc: be consistent when checking strcmp() return"
iio: adc: stm32: fix common clock rate
iio: adc: ina219: Avoid underflow for sleeping time
iio: trigger: stm32-timer: add enable attribute
iio: trigger: stm32-timer: fix get/set down count direction
iio: trigger: stm32-timer: fix write_raw return value
iio: trigger: stm32-timer: fix quadrature mode get routine
iio: bmp280: properly initialize device for humidity reading

Commit c4ea41ba195d ("binder: use group leader instead of open thread")'
was incomplete and didn't update a check in binder_mmap(), causing all
mmap() calls into the binder driver to fail.

Signed-off-by: Martijn Coenen <maco@android.com>
Tested-by: John Stultz <john.stultz@linaro.org>
Cc: stable <stable@vger.kernel.org>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

Commit c54451a "iommu/arm-smmu: Fix the error path in arm_smmu_add_device"
removed fwspec assignment in legacy_binding path as redundant which is
wrong. It needs to be updated after fwspec initialisation in
arm_smmu_register_legacy_master() as it is dereferenced later. Without
this there is a NULL-pointer dereference panic during boot on some hosts.

Signed-off-by: Artem Savkov <asavkov@redhat.com>
Reviewed-by: Robin Murphy <robin.murphy@arm.com>
Acked-by: Will Deacon <will.deacon@arm.com>
Signed-off-by: Joerg Roedel <jroedel@suse.de>

Pull NTB fixes from Jon Mason:
"NTB bug fixes to address an incorrect ntb_mw_count reference in the
NTB transport, improperly bringing down the link if SPADs are
corrupted, and an out-of-order issue regarding link negotiation and
data passing"

* tag 'ntb-4.13-bugfixes' of git://github.com/jonmason/ntb:
ntb: ntb_test: ensure the link is up before trying to configure the mws
ntb: transport shouldn't disable link due to bogus values in SPADs
ntb: use correct mw_count function in ntb_tool and ntb_transport

Jonathan writes:

Second set of IIO fixes for the 4.13 cycle.

Given the late stage of this series, some more involved fixes have been
held back for the upcoming merge window.

The hid-sensor issue has been causing problems for a long time so it
is great to have that one finally fixed! No more bug reports for the
userspace guys (well about that anyway).

* documentation
- some warning fixes due to missing colons in kernel-doc.
* adis16480
- fix accel scale factor.
* bmp280
- properly initialize the device for humidity readings - without this
the humidity readings may be skipped and a magic value of 0x8000 returned.
* hid-sensor-strigger
- fix a race with user space when powering up the sensor.
* ina291
- Avoid an underflow for the sleeping time as a result of supporting the
fastest rates.
* st-magnetometer
- Fix the status register address for hte LSM303AGR,
- Remove the ihl property for LSM303AGR as the sensor doesn't support
active low for the dataready line.
* stm32-adc
- Fix use of a common clock rate.
* stm32-timer
- fix the quadrature mode get routine to account for the magic 0 value.
set on boot.
- fix the return value of write_raw,
- fix the get/set down count direction as the enum value was not being
converted to the relevant bit field,
- add an enable attribute to actually turn it on when in encoder mode,
- missing mask when reading the trigger mode.

The register_syscore_ops() function takes a mutex and might
sleep. In the IOMMU initialization code it is invoked during
irq-remapping setup already, where irqs are disabled.

This causes a schedule-while-atomic bug:

BUG: sleeping function called from invalid context at kernel/locking/mutex.c:747
in_atomic(): 0, irqs_disabled(): 1, pid: 1, name: swapper/0
no locks held by swapper/0/1.
irq event stamp: 304
hardirqs last enabled at (303): [<ffffffff818a87b6>] _raw_spin_unlock_irqrestore+0x36/0x60
hardirqs last disabled at (304): [<ffffffff8235d440>] enable_IR_x2apic+0x79/0x196
softirqs last enabled at (36): [<ffffffff818ae75f>] __do_softirq+0x35f/0x4ec
softirqs last disabled at (31): [<ffffffff810c1955>] irq_exit+0x105/0x120
CPU: 0 PID: 1 Comm: swapper/0 Not tainted 4.13.0-rc2.1.el7a.test.x86_64.debug #1
Hardware name: PowerEdge C6145 /040N24, BIOS 3.5.0 10/28/2014
Call Trace:
dump_stack+0x85/0xca
___might_sleep+0x22a/0x260
__might_sleep+0x4a/0x80
__mutex_lock+0x58/0x960
? iommu_completion_wait.part.17+0xb5/0x160
? register_syscore_ops+0x1d/0x70
? iommu_flush_all_caches+0x120/0x150
mutex_lock_nested+0x1b/0x20
register_syscore_ops+0x1d/0x70
state_next+0x119/0x910
iommu_go_to_state+0x29/0x30
amd_iommu_enable+0x13/0x23

Fix it by moving the register_syscore_ops() call to the next
initialization step, which runs with irqs enabled.

Reported-by: Artem Savkov <asavkov@redhat.com>
Tested-by: Artem Savkov <asavkov@redhat.com>
Acked-by: Thomas Gleixner <tglx@linutronix.de>
Fixes: 2c0ae1720c09 ('iommu/amd: Convert iommu initialization to state machine')
Signed-off-by: Joerg Roedel <jroedel@suse.de>

The "lock_page_killable()" function waits for exclusive access to the
page lock bit using the WQ_FLAG_EXCLUSIVE bit in the waitqueue entry
set.

That means that if it gets woken up, other waiters may have been
skipped.

That, in turn, means that if it sees the page being unlocked, it *must*
take that lock and return success, even if a lethal signal is also
pending.

So instead of checking for lethal signals first, we need to check for
them after we've checked the actual bit that we were waiting for. Even
if that might then delay the killing of the process.

This matches the order of the old "wait_on_bit_lock()" infrastructure
that the page locking used to use (and is still used in a few other
areas).

Note that if we still return an error after having unsuccessfully tried
to acquire the page lock, that is ok: that means that some other thread
was able to get ahead of us and lock the page, and when that other
thread then unlocks the page, the wakeup event will be repeated. So any
other pending waiters will now get properly woken up.

Fixes: 62906027091f ("mm: add PageWaiters indicating tasks are waiting for a page bit")
Cc: Nick Piggin <npiggin@gmail.com>
Cc: Peter Zijlstra <peterz@infradead.org>
Cc: Mel Gorman <mgorman@techsingularity.net>
Cc: Jan Kara <jack@suse.cz>
Cc: Davidlohr Bueso <dave@stgolabs.net>
Cc: Andi Kleen <ak@linux.intel.com>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>

After the link tests, there is a race on one side of the test for
the link coming up. It's possible, in some cases, for the test script
to write to the 'peer_trans' files before the link has come up.

To fix this, we simply use the link event file to ensure both sides
see the link as up before continuning.

Signed-off-by: Logan Gunthorpe <logang@deltatee.com>
Acked-by: Allen Hubbe <Allen.Hubbe@dell.com>
Signed-off-by: Jon Mason <jdmason@kudzu.us>
Fixes: a9c59ef77458 ("ntb_test: Add a selftest script for the NTB subsystem")

Add support for USB Device Rosewill RNX-N150NUB.
VendorID: 0x0bda, ProductID: 0xffef

Signed-off-by: Charles Milette <charles.milette@gmail.com>
Cc: stable <stable@vger.kernel.org>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>