Pull arch/csky fixes from Guo Ren:
"Here are some fixup patches for 5.0-rc6"

* tag 'csky-for-linus-5.0-rc6' of git://github.com/c-sky/csky-linux:
csky: Fixup dead loop in show_stack
csky: Fixup io-range page attribute for mmap("/dev/mem")
csky: coding convention: Use task_stack_page
csky: Fixup wrong pt_regs size
csky: Fixup _PAGE_GLOBAL bit for 610 tlb entry

Pull i2c fixes from Wolfram Sang:
"Two more driver bugfixes"

* 'i2c/for-current' of git://git.kernel.org/pub/scm/linux/kernel/git/wsa/linux:
i2c: bcm2835: Clear current buffer pointers and counts after a transfer
i2c: cadence: Fix the hold bit setting

When STACKTRACE is enabled, we must pass fp as stack for unwind,
otherwise random value in stack will casue a dead loop.

Signed-off-by: Guo Ren <ren_guo@c-sky.com>
Reported-by: Lu Baoquan <lu.baoquan@intellif.com>

Pull input fixes from Dmitry Torokhov:

- tweaks to Elan drivers (both PS/2 and I2C) to support new devices.
Also revert of one of IDs as that device should really be driven by
i2c-hid + hid-multitouch

- a few drivers have been switched to set_brightness_blocking() call
because they either were sleeping the their set_brightness()
implementation or used workqueue but were not canceling it on unbind.

- ps2-gpio and matrix_keypad needed to [properly] flush their works to
avoid potential use-after-free on unbind.

- other miscellaneous fixes.

* 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/dtor/input:
Input: elan_i2c - add ACPI ID for touchpad in Lenovo V330-15ISK
Input: st-keyscan - fix potential zalloc NULL dereference
Input: apanel - switch to using brightness_set_blocking()
Revert "Input: elan_i2c - add ACPI ID for touchpad in ASUS Aspire F5-573G"
Input: qt2160 - switch to using brightness_set_blocking()
Input: matrix_keypad - use flush_delayed_work()
Input: ps2-gpio - flush TX work when closing port
Input: cap11xx - switch to using set_brightness_blocking()
Input: elantech - enable 3rd button support on Fujitsu CELSIUS H780
Input: bma150 - register input device after setting private data
Input: pwm-vibra - stop regulator after disabling pwm, not before
Input: pwm-vibra - prevent unbalanced regulator
Input: snvs_pwrkey - allow selecting driver for i.MX 7D

The driver's interrupt handler checks whether a message is currently
being handled with the curr_msg pointer. When it is NULL, the interrupt
is considered to be unexpected. Similarly, the i2c_start_transfer
routine checks for the remaining number of messages to handle in
num_msgs.

However, these values are never cleared and always keep the message and
number relevant to the latest transfer (which might be done already and
the underlying message memory might have been freed).

When an unexpected interrupt hits with the DONE bit set, the isr will
then try to access the flags field of the curr_msg structure, leading
to a fatal page fault.

The msg_buf and msg_buf_remaining fields are also never cleared at the
end of the transfer, which can lead to similar pitfalls.

Fix these issues by introducing a cleanup function and always calling
it after a transfer is finished.

Fixes: e2474541032d ("i2c: bcm2835: Fix hang for writing messages larger than 16 bytes")
Signed-off-by: Paul Kocialkowski <paul.kocialkowski@bootlin.com>
Acked-by: Stefan Wahren <stefan.wahren@i2se.com>
Signed-off-by: Wolfram Sang <wsa@the-dreams.de>

Some user space drivers need accessing IO address and IO remap need
SO(strong order) page-attribute to make IO operation correct. So we
need add SO-page-attr for all non-memory address.

Signed-off-by: Guo Ren <ren_guo@c-sky.com>
Reported-by: Fan Xiaodong <xiaodong.fan@boyahualu.com>

Pull KVM fixes from Paolo Bonzini:
"A somewhat bigger ARM update, and the usual smattering of x86 bug
fixes"

* tag 'for-linus' of git://git.kernel.org/pub/scm/virt/kvm/kvm:
kvm: vmx: Fix entry number check for add_atomic_switch_msr()
KVM: x86: Recompute PID.ON when clearing PID.SN
KVM: nVMX: Restore a preemption timer consistency check
x86/kvm/nVMX: read from MSR_IA32_VMX_PROCBASED_CTLS2 only when it is available
KVM: arm64: Forbid kprobing of the VHE world-switch code
KVM: arm64: Relax the restriction on using stage2 PUD huge mapping
arm: KVM: Add missing kvm_stage2_has_pmd() helper
KVM: arm/arm64: vgic: Always initialize the group of private IRQs
arm/arm64: KVM: Don't panic on failure to properly reset system registers
arm/arm64: KVM: Allow a VCPU to fully reset itself
KVM: arm/arm64: Reset the VCPU without preemption and vcpu state loaded
arm64: KVM: Don't generate UNDEF when LORegion feature is present
KVM: arm/arm64: vgic: Make vgic_cpu->ap_list_lock a raw_spinlock
KVM: arm/arm64: vgic: Make vgic_dist->lpi_list_lock a raw_spinlock
KVM: arm/arm64: vgic: Make vgic_irq->irq_lock a raw_spinlock

This adds ELAN0617 to the ACPI table to support Elan touchpad found in
Lenovo V330-15ISK.

Signed-off-by: Mauro Ciancio <mauro@acadeu.com>
Cc: stable@vger.kernel.org
Signed-off-by: Dmitry Torokhov <dmitry.torokhov@gmail.com>

In case the hold bit is not needed we are carrying the old values.
Fix the same by resetting the bit when not needed.

Fixes the sporadic i2c bus lockups on National Instruments
Zynq-based devices.

Fixes: df8eb5691c48 ("i2c: Add driver for Cadence I2C controller")
Reported-by: Kyle Roeschley <kyle.roeschley@ni.com>
Acked-by: Michal Simek <michal.simek@xilinx.com>
Signed-off-by: Shubhrajyoti Datta <shubhrajyoti.datta@xilinx.com>
Tested-by: Kyle Roeschley <kyle.roeschley@ni.com>
Signed-off-by: Wolfram Sang <wsa@the-dreams.de>

Use task_stack_page instead of p->stack to get stack. Follow the coding
convention style. Also for init_stack, the same with other archs.

Signed-off-by: Guo Ren <ren_guo@c-sky.com>

Pull ARM SoC fixes from Arnd Bergmann:
"This week is a much smaller update, containing fixes only for TI OMAP,
NXP i.MX and Rockchips platforms:

omap:
- omap4 had problems with lost timer interrupts
- another IRQ handling issue with OMAP5
- A workaround for a regression in the pwm-omap-dmtimer driver

NXP i.MX:
- eMMC was broken on the new imx8mq-evk board

Rockchip:
- a fix for new dtc graph warnings and a regulator fix for rock64
- USB support broke on rk3328-rock64"

* tag 'armsoc-fixes' of git://git.kernel.org/pub/scm/linux/kernel/git/soc/soc:
ARM: OMAP2+: fix lack of timer interrupts on CPU1 after hotplug
arm64: dts: imx8mq: Fix boot from eMMC
ARM: OMAP2+: Variable "reg" in function omap4_dsi_mux_pads() could be uninitialized
ARM: dts: Configure clock parent for pwm vibra
bus: ti-sysc: Fix timer handling with drop pm_runtime_irq_safe()
arm64: dts: rockchip: enable usb-host regulators at boot on rk3328-rock64
arm64: dts: rockchip: fix graph_port warning on rk3399 bob kevin and excavator
ARM: OMAP5+: Fix inverted nirq pin interrupts with irq_set_type
clocksource: timer-ti-dm: Fix pwm dmtimer usage of fck reparenting
ARM: dts: rockchip: remove qos_cif1 from rk3188 power-domain

Commit ca83b4a7f2d068da79a0 ("x86/KVM/VMX: Add find_msr() helper function")
introduces the helper function find_msr(), which returns -ENOENT when
not find the msr in vmx->msr_autoload.guest/host. Correct checking contion
of no more available entry in vmx->msr_autoload.

Fixes: ca83b4a7f2d0 ("x86/KVM/VMX: Add find_msr() helper function")
Cc: stable@vger.kernel.org
Signed-off-by: Xiaoyao Li <xiaoyao.li@linux.intel.com>
Signed-off-by: Paolo Bonzini <pbonzini@redhat.com>

This patch fixes the following static checker warning:

drivers/input/keyboard/st-keyscan.c:156 keyscan_probe()
error: potential zalloc NULL dereference: 'keypad_data->input_dev'

Reported-by: Dan Carpenter <dan.carpenter@oracle.com>
Signed-off-by: Gabriel Fernandez <gabriel.fernandez@st.com>
Signed-off-by: Dmitry Torokhov <dmitry.torokhov@gmail.com>