i3c: dw-i3c-master: Set SIR_REJECT in DAT on device attach and reattach

The DesignWare I3C master controller ACKs IBIs as soon as a valid
Device Address Table (DAT) entry is present. This can create a race
between device attachment (after DAA) and the point where the client
driver enables IBIs via i3c_device_enable_ibi().

Set DEV_ADDR_TABLE_SIR_REJECT in the DAT entry during
attach_i3c_dev() and reattach_i3c_dev() so that IBIs are rejected
by default. The bit is managed thereafter by the existing
dw_i3c_master_set_sir_enabled() function, which clears it in
enable_ibi() after ENEC is issued, and restores it in disable_ibi()
after DISEC.

Fixes: 1dd728f5d4d4 ("i3c: master: Add driver for Synopsys DesignWare IP")
Signed-off-by: Adrian Ng Ho Yin <[e-mail]>
Reviewed-by: Frank Li <[e-mail]>
Link: https://patch.msgid.link/53f5b8[e-mail]
Signed-off-by: Alexandre Belloni <[e-mail]>

drivers/i3c/master/dw-i3c-master.c

···
 		master->free_pos &= ~BIT(pos);
 	}
 
-	writel(DEV_ADDR_TABLE_DYNAMIC_ADDR(dev->info.dyn_addr),
+	writel(DEV_ADDR_TABLE_DYNAMIC_ADDR(dev->info.dyn_addr) | DEV_ADDR_TABLE_SIR_REJECT,
 	       master->regs +
 	       DEV_ADDR_TABLE_LOC(master->datstartaddr, data->index));
 
···
 	master->free_pos &= ~BIT(pos);
 	i3c_dev_set_master_data(dev, data);
 
-	writel(DEV_ADDR_TABLE_DYNAMIC_ADDR(master->devs[pos].addr),
+	writel(DEV_ADDR_TABLE_DYNAMIC_ADDR(master->devs[pos].addr) | DEV_ADDR_TABLE_SIR_REJECT,
 	       master->regs +
 	       DEV_ADDR_TABLE_LOC(master->datstartaddr, data->index));