ieee1394: support for speeds greater than S800

The hard-wired configuration of the top speed (until now S800) was
unnecessary, remove it.

If the local link layer controller supports S1600 or S3200, we now
assume this speed for all present 1394b PHYs (except if they are
behind 1394a repeaters) until nodemgr figured out the actual speed
while fetching the config ROM.

Signed-off-by: Stefan Richter <[e-mail]>

drivers/ieee1394/ieee1394.h

···
 #define IEEE1394_SPEED_800	0x03
 #define IEEE1394_SPEED_1600	0x04
 #define IEEE1394_SPEED_3200	0x05
-
-/* The current highest tested speed supported by the subsystem */
-#define IEEE1394_SPEED_MAX	IEEE1394_SPEED_800
+#define IEEE1394_SPEED_MAX	IEEE1394_SPEED_3200
 
 /* Maps speed values above to a string representation */
 extern const char *hpsb_speedto_str[];

drivers/ieee1394/ieee1394_core.c

···
 	u8 cldcnt[nodecount];
 	u8 *map = host->speed_map;
 	u8 *speedcap = host->speed;
+	u8 local_link_speed = host->csr.lnk_spd;
 	struct selfid *sid;
 	struct ext_selfid *esid;
 	int i, j, n;
···
 			if (sid->port2 == SELFID_PORT_CHILD) cldcnt[n]++;
 
 			speedcap[n] = sid->speed;
-			if (speedcap[n] > host->csr.lnk_spd)
-				speedcap[n] = host->csr.lnk_spd;
+			if (speedcap[n] > local_link_speed)
+				speedcap[n] = local_link_speed;
 			n--;
 		}
 	}
···
 		}
 	}
 
-#if SELFID_SPEED_UNKNOWN != IEEE1394_SPEED_MAX
-	/* assume maximum speed for 1394b PHYs, nodemgr will correct it */
-	for (n = 0; n < nodecount; n++)
-		if (speedcap[n] == SELFID_SPEED_UNKNOWN)
-			speedcap[n] = IEEE1394_SPEED_MAX;
-#endif
+	/* assume a maximum speed for 1394b PHYs, nodemgr will correct it */
+	if (local_link_speed > SELFID_SPEED_UNKNOWN)
+		for (i = 0; i < nodecount; i++)
+			if (speedcap[i] == SELFID_SPEED_UNKNOWN)
+				speedcap[i] = local_link_speed;
 }