[PATCH] sky2: speed setting fix

Users report problems w/ auto-negotiation disabled and the link set
to 100/Half or 10/Half. Problems range from poor performance to no
link at all.

The current sky2 code does not set things properly on link up if
autonegotiation is disabled. Plus it does not contemplate a 10Mbit
setting at all. This patch corrects that.

Signed-off-by: John W. Linville <[e-mail]>
Signed-off-by: Stephen Hemminger <[e-mail]>
Signed-off-by: Jeff Garzik <[e-mail]>

drivers/net/sky2.c

···
 
 		switch (sky2->speed) {
 		case SPEED_1000:
+			reg &= ~GM_GPCR_SPEED_100;
 			reg |= GM_GPCR_SPEED_1000;
-			/* fallthru */
+			break;
 		case SPEED_100:
+			reg &= ~GM_GPCR_SPEED_1000;
 			reg |= GM_GPCR_SPEED_100;
+			break;
+		case SPEED_10:
+			reg &= ~(GM_GPCR_SPEED_1000 | GM_GPCR_SPEED_100);
+			break;
 		}
 
 		if (sky2->duplex == DUPLEX_FULL)
···
 	sky2_write8(hw, SK_REG(port, GMAC_IRQ_MSK), GMAC_DEF_MSK);
 
 	reg = gma_read16(hw, port, GM_GP_CTRL);
+	if (sky2->autoneg == AUTONEG_DISABLE) {
+		reg |= GM_GPCR_AU_ALL_DIS;
+
+		/* Is write/read necessary?  Copied from sky2_mac_init */
+		gma_write16(hw, port, GM_GP_CTRL, reg);
+		gma_read16(hw, port, GM_GP_CTRL);
+
+		switch (sky2->speed) {
+		case SPEED_1000:
+			reg &= ~GM_GPCR_SPEED_100;
+			reg |= GM_GPCR_SPEED_1000;
+			break;
+		case SPEED_100:
+			reg &= ~GM_GPCR_SPEED_1000;
+			reg |= GM_GPCR_SPEED_100;
+			break;
+		case SPEED_10:
+			reg &= ~(GM_GPCR_SPEED_1000 | GM_GPCR_SPEED_100);
+			break;
+		}
+	} else
+		reg &= ~GM_GPCR_AU_ALL_DIS;
+
 	if (sky2->duplex == DUPLEX_FULL || sky2->autoneg == AUTONEG_ENABLE)
 		reg |= GM_GPCR_DUP_FULL;