drm/radeon: fix bad DMA from INTERRUPT_CNTL2

The INTERRUPT_CNTL2 register expects a valid DMA address, but is
currently set with a GPU MC address. This can cause problems on
systems that detect the resulting DMA read from an invalid address
(found on a Power8 guest).

Instead, use the DMA address of the dummy page because it will always
be safe.

Fixes: d8f60cfc9345 ("drm/radeon/kms: Add support for interrupts on r6xx/r7xx chips (v3)")
Fixes: 25a857fbe973 ("drm/radeon/kms: add support for interrupts on SI")
Fixes: a59781bbe528 ("drm/radeon: add support for interrupts on CIK (v5)")
Signed-off-by: Sam Bobroff <[e-mail]>
Signed-off-by: Alex Deucher <[e-mail]>

drivers/gpu/drm/radeon/cik.c

···
 	}
 
 	/* setup interrupt control */
-	/* XXX this should actually be a bus address, not an MC address. same on older asics */
-	WREG32(INTERRUPT_CNTL2, rdev->ih.gpu_addr >> 8);
+	/* set dummy read address to dummy page address */
+	WREG32(INTERRUPT_CNTL2, rdev->dummy_page.addr >> 8);
 	interrupt_cntl = RREG32(INTERRUPT_CNTL);
 	/* IH_DUMMY_RD_OVERRIDE=0 - dummy read disabled with msi, enabled without msi
 	 * IH_DUMMY_RD_OVERRIDE=1 - dummy read controlled by IH_DUMMY_RD_EN

drivers/gpu/drm/radeon/r600.c

···
 	}
 
 	/* setup interrupt control */
-	/* set dummy read address to ring address */
-	WREG32(INTERRUPT_CNTL2, rdev->ih.gpu_addr >> 8);
+	/* set dummy read address to dummy page address */
+	WREG32(INTERRUPT_CNTL2, rdev->dummy_page.addr >> 8);
 	interrupt_cntl = RREG32(INTERRUPT_CNTL);
 	/* IH_DUMMY_RD_OVERRIDE=0 - dummy read disabled with msi, enabled without msi
 	 * IH_DUMMY_RD_OVERRIDE=1 - dummy read controlled by IH_DUMMY_RD_EN

drivers/gpu/drm/radeon/si.c

···
 	}
 
 	/* setup interrupt control */
-	/* set dummy read address to ring address */
-	WREG32(INTERRUPT_CNTL2, rdev->ih.gpu_addr >> 8);
+	/* set dummy read address to dummy page address */
+	WREG32(INTERRUPT_CNTL2, rdev->dummy_page.addr >> 8);
 	interrupt_cntl = RREG32(INTERRUPT_CNTL);
 	/* IH_DUMMY_RD_OVERRIDE=0 - dummy read disabled with msi, enabled without msi
 	 * IH_DUMMY_RD_OVERRIDE=1 - dummy read controlled by IH_DUMMY_RD_EN