Linux kernel mirror (for testing)
git.kernel.org/pub/scm/linux/kernel/git/torvalds/linux.git
tjh.dev
kernel
os
linux
1#ifndef MFD_TMIO_H
2#define MFD_TMIO_H
3
4#include <linux/device.h>
5#include <linux/fb.h>
6#include <linux/io.h>
7#include <linux/jiffies.h>
8#include <linux/mmc/card.h>
9#include <linux/platform_device.h>
10#include <linux/pm_runtime.h>
11
12#define tmio_ioread8(addr) readb(addr)
13#define tmio_ioread16(addr) readw(addr)
14#define tmio_ioread16_rep(r, b, l) readsw(r, b, l)
15#define tmio_ioread32(addr) \
16 (((u32) readw((addr))) | (((u32) readw((addr) + 2)) << 16))
17
18#define tmio_iowrite8(val, addr) writeb((val), (addr))
19#define tmio_iowrite16(val, addr) writew((val), (addr))
20#define tmio_iowrite16_rep(r, b, l) writesw(r, b, l)
21#define tmio_iowrite32(val, addr) \
22 do { \
23 writew((val), (addr)); \
24 writew((val) >> 16, (addr) + 2); \
25 } while (0)
26
27#define CNF_CMD 0x04
28#define CNF_CTL_BASE 0x10
29#define CNF_INT_PIN 0x3d
30#define CNF_STOP_CLK_CTL 0x40
31#define CNF_GCLK_CTL 0x41
32#define CNF_SD_CLK_MODE 0x42
33#define CNF_PIN_STATUS 0x44
34#define CNF_PWR_CTL_1 0x48
35#define CNF_PWR_CTL_2 0x49
36#define CNF_PWR_CTL_3 0x4a
37#define CNF_CARD_DETECT_MODE 0x4c
38#define CNF_SD_SLOT 0x50
39#define CNF_EXT_GCLK_CTL_1 0xf0
40#define CNF_EXT_GCLK_CTL_2 0xf1
41#define CNF_EXT_GCLK_CTL_3 0xf9
42#define CNF_SD_LED_EN_1 0xfa
43#define CNF_SD_LED_EN_2 0xfe
44
45#define SDCREN 0x2 /* Enable access to MMC CTL regs. (flag in COMMAND_REG)*/
46
47#define sd_config_write8(base, shift, reg, val) \
48 tmio_iowrite8((val), (base) + ((reg) << (shift)))
49#define sd_config_write16(base, shift, reg, val) \
50 tmio_iowrite16((val), (base) + ((reg) << (shift)))
51#define sd_config_write32(base, shift, reg, val) \
52 do { \
53 tmio_iowrite16((val), (base) + ((reg) << (shift))); \
54 tmio_iowrite16((val) >> 16, (base) + ((reg + 2) << (shift))); \
55 } while (0)
56
57/* tmio MMC platform flags */
58#define TMIO_MMC_WRPROTECT_DISABLE (1 << 0)
59/*
60 * Some controllers can support a 2-byte block size when the bus width
61 * is configured in 4-bit mode.
62 */
63#define TMIO_MMC_BLKSZ_2BYTES (1 << 1)
64/*
65 * Some controllers can support SDIO IRQ signalling.
66 */
67#define TMIO_MMC_SDIO_IRQ (1 << 2)
68
69/* Some features are only available or tested on RCar Gen2 or later */
70#define TMIO_MMC_MIN_RCAR2 (1 << 3)
71
72/*
73 * Some controllers require waiting for the SD bus to become
74 * idle before writing to some registers.
75 */
76#define TMIO_MMC_HAS_IDLE_WAIT (1 << 4)
77/*
78 * A GPIO is used for card hotplug detection. We need an extra flag for this,
79 * because 0 is a valid GPIO number too, and requiring users to specify
80 * cd_gpio < 0 to disable GPIO hotplug would break backwards compatibility.
81 */
82#define TMIO_MMC_USE_GPIO_CD (1 << 5)
83
84/*
85 * Some controllers doesn't have over 0x100 register.
86 * it is used to checking accessibility of
87 * CTL_SD_CARD_CLK_CTL / CTL_CLK_AND_WAIT_CTL
88 */
89#define TMIO_MMC_HAVE_HIGH_REG (1 << 6)
90
91/*
92 * Some controllers have CMD12 automatically
93 * issue/non-issue register
94 */
95#define TMIO_MMC_HAVE_CMD12_CTRL (1 << 7)
96
97/*
98 * Some controllers needs to set 1 on SDIO status reserved bits
99 */
100#define TMIO_MMC_SDIO_STATUS_QUIRK (1 << 8)
101
102/*
103 * Some controllers allows to set SDx actual clock
104 */
105#define TMIO_MMC_CLK_ACTUAL (1 << 10)
106
107int tmio_core_mmc_enable(void __iomem *cnf, int shift, unsigned long base);
108int tmio_core_mmc_resume(void __iomem *cnf, int shift, unsigned long base);
109void tmio_core_mmc_pwr(void __iomem *cnf, int shift, int state);
110void tmio_core_mmc_clk_div(void __iomem *cnf, int shift, int state);
111
112struct dma_chan;
113
114/*
115 * data for the MMC controller
116 */
117struct tmio_mmc_data {
118 void *chan_priv_tx;
119 void *chan_priv_rx;
120 unsigned int hclk;
121 unsigned long capabilities;
122 unsigned long capabilities2;
123 unsigned long flags;
124 u32 ocr_mask; /* available voltages */
125 unsigned int cd_gpio;
126 int alignment_shift;
127 dma_addr_t dma_rx_offset;
128 void (*set_pwr)(struct platform_device *host, int state);
129 void (*set_clk_div)(struct platform_device *host, int state);
130};
131
132/*
133 * data for the NAND controller
134 */
135struct tmio_nand_data {
136 struct nand_bbt_descr *badblock_pattern;
137 struct mtd_partition *partition;
138 unsigned int num_partitions;
139};
140
141#define FBIO_TMIO_ACC_WRITE 0x7C639300
142#define FBIO_TMIO_ACC_SYNC 0x7C639301
143
144struct tmio_fb_data {
145 int (*lcd_set_power)(struct platform_device *fb_dev,
146 bool on);
147 int (*lcd_mode)(struct platform_device *fb_dev,
148 const struct fb_videomode *mode);
149 int num_modes;
150 struct fb_videomode *modes;
151
152 /* in mm: size of screen */
153 int height;
154 int width;
155};
156
157
158#endif