tjh.dev
Linux kernel mirror (for testing)
git.kernel.org/pub/scm/linux/kernel/git/torvalds/linux.git
kernel
os
linux
1/* vi: ts=8 sw=8
2 *
3 * TI 3410/5052 USB Serial Driver Header
4 *
5 * Copyright (C) 2004 Texas Instruments
6 *
7 * This driver is based on the Linux io_ti driver, which is
8 * Copyright (C) 2000-2002 Inside Out Networks
9 * Copyright (C) 2001-2002 Greg Kroah-Hartman
10 *
11 * This program is free software; you can redistribute it and/or modify
12 * it under the terms of the GNU General Public License as published by
13 * the Free Software Foundation; either version 2 of the License, or
14 * (at your option) any later version.
15 *
16 * For questions or problems with this driver, contact Texas Instruments
17 * technical support, or Al Borchers <alborchers@steinerpoint.com>, or
18 * Peter Berger <pberger@brimson.com>.
19 */
20
21#ifndef _TI_3410_5052_H_
22#define _TI_3410_5052_H_
23
24/* Configuration ids */
25#define TI_BOOT_CONFIG 1
26#define TI_ACTIVE_CONFIG 2
27
28/* Vendor and product ids */
29#define TI_VENDOR_ID 0x0451
30#define IBM_VENDOR_ID 0x04b3
31#define TI_3410_PRODUCT_ID 0x3410
32#define IBM_4543_PRODUCT_ID 0x4543
33#define IBM_454B_PRODUCT_ID 0x454b
34#define IBM_454C_PRODUCT_ID 0x454c
35#define TI_3410_EZ430_ID 0xF430 /* TI ez430 development tool */
36#define TI_5052_BOOT_PRODUCT_ID 0x5052 /* no EEPROM, no firmware */
37#define TI_5152_BOOT_PRODUCT_ID 0x5152 /* no EEPROM, no firmware */
38#define TI_5052_EEPROM_PRODUCT_ID 0x505A /* EEPROM, no firmware */
39#define TI_5052_FIRMWARE_PRODUCT_ID 0x505F /* firmware is running */
40#define FRI2_PRODUCT_ID 0x5053 /* Fish River Island II */
41
42/* Multi-Tech vendor and product ids */
43#define MTS_VENDOR_ID 0x06E0
44#define MTS_GSM_NO_FW_PRODUCT_ID 0xF108
45#define MTS_CDMA_NO_FW_PRODUCT_ID 0xF109
46#define MTS_CDMA_PRODUCT_ID 0xF110
47#define MTS_GSM_PRODUCT_ID 0xF111
48#define MTS_EDGE_PRODUCT_ID 0xF112
49#define MTS_MT9234MU_PRODUCT_ID 0xF114
50#define MTS_MT9234ZBA_PRODUCT_ID 0xF115
51#define MTS_MT9234ZBAOLD_PRODUCT_ID 0x0319
52
53/* Abbott Diabetics vendor and product ids */
54#define ABBOTT_VENDOR_ID 0x1a61
55#define ABBOTT_PRODUCT_ID 0x3410
56
57/* Commands */
58#define TI_GET_VERSION 0x01
59#define TI_GET_PORT_STATUS 0x02
60#define TI_GET_PORT_DEV_INFO 0x03
61#define TI_GET_CONFIG 0x04
62#define TI_SET_CONFIG 0x05
63#define TI_OPEN_PORT 0x06
64#define TI_CLOSE_PORT 0x07
65#define TI_START_PORT 0x08
66#define TI_STOP_PORT 0x09
67#define TI_TEST_PORT 0x0A
68#define TI_PURGE_PORT 0x0B
69#define TI_RESET_EXT_DEVICE 0x0C
70#define TI_WRITE_DATA 0x80
71#define TI_READ_DATA 0x81
72#define TI_REQ_TYPE_CLASS 0x82
73
74/* Module identifiers */
75#define TI_I2C_PORT 0x01
76#define TI_IEEE1284_PORT 0x02
77#define TI_UART1_PORT 0x03
78#define TI_UART2_PORT 0x04
79#define TI_RAM_PORT 0x05
80
81/* Modem status */
82#define TI_MSR_DELTA_CTS 0x01
83#define TI_MSR_DELTA_DSR 0x02
84#define TI_MSR_DELTA_RI 0x04
85#define TI_MSR_DELTA_CD 0x08
86#define TI_MSR_CTS 0x10
87#define TI_MSR_DSR 0x20
88#define TI_MSR_RI 0x40
89#define TI_MSR_CD 0x80
90#define TI_MSR_DELTA_MASK 0x0F
91#define TI_MSR_MASK 0xF0
92
93/* Line status */
94#define TI_LSR_OVERRUN_ERROR 0x01
95#define TI_LSR_PARITY_ERROR 0x02
96#define TI_LSR_FRAMING_ERROR 0x04
97#define TI_LSR_BREAK 0x08
98#define TI_LSR_ERROR 0x0F
99#define TI_LSR_RX_FULL 0x10
100#define TI_LSR_TX_EMPTY 0x20
101
102/* Line control */
103#define TI_LCR_BREAK 0x40
104
105/* Modem control */
106#define TI_MCR_LOOP 0x04
107#define TI_MCR_DTR 0x10
108#define TI_MCR_RTS 0x20
109
110/* Mask settings */
111#define TI_UART_ENABLE_RTS_IN 0x0001
112#define TI_UART_DISABLE_RTS 0x0002
113#define TI_UART_ENABLE_PARITY_CHECKING 0x0008
114#define TI_UART_ENABLE_DSR_OUT 0x0010
115#define TI_UART_ENABLE_CTS_OUT 0x0020
116#define TI_UART_ENABLE_X_OUT 0x0040
117#define TI_UART_ENABLE_XA_OUT 0x0080
118#define TI_UART_ENABLE_X_IN 0x0100
119#define TI_UART_ENABLE_DTR_IN 0x0800
120#define TI_UART_DISABLE_DTR 0x1000
121#define TI_UART_ENABLE_MS_INTS 0x2000
122#define TI_UART_ENABLE_AUTO_START_DMA 0x4000
123
124/* Parity */
125#define TI_UART_NO_PARITY 0x00
126#define TI_UART_ODD_PARITY 0x01
127#define TI_UART_EVEN_PARITY 0x02
128#define TI_UART_MARK_PARITY 0x03
129#define TI_UART_SPACE_PARITY 0x04
130
131/* Stop bits */
132#define TI_UART_1_STOP_BITS 0x00
133#define TI_UART_1_5_STOP_BITS 0x01
134#define TI_UART_2_STOP_BITS 0x02
135
136/* Bits per character */
137#define TI_UART_5_DATA_BITS 0x00
138#define TI_UART_6_DATA_BITS 0x01
139#define TI_UART_7_DATA_BITS 0x02
140#define TI_UART_8_DATA_BITS 0x03
141
142/* 232/485 modes */
143#define TI_UART_232 0x00
144#define TI_UART_485_RECEIVER_DISABLED 0x01
145#define TI_UART_485_RECEIVER_ENABLED 0x02
146
147/* Pipe transfer mode and timeout */
148#define TI_PIPE_MODE_CONTINOUS 0x01
149#define TI_PIPE_MODE_MASK 0x03
150#define TI_PIPE_TIMEOUT_MASK 0x7C
151#define TI_PIPE_TIMEOUT_ENABLE 0x80
152
153/* Config struct */
154struct ti_uart_config {
155 __u16 wBaudRate;
156 __u16 wFlags;
157 __u8 bDataBits;
158 __u8 bParity;
159 __u8 bStopBits;
160 char cXon;
161 char cXoff;
162 __u8 bUartMode;
163} __attribute__((packed));
164
165/* Get port status */
166struct ti_port_status {
167 __u8 bCmdCode;
168 __u8 bModuleId;
169 __u8 bErrorCode;
170 __u8 bMSR;
171 __u8 bLSR;
172} __attribute__((packed));
173
174/* Purge modes */
175#define TI_PURGE_OUTPUT 0x00
176#define TI_PURGE_INPUT 0x80
177
178/* Read/Write data */
179#define TI_RW_DATA_ADDR_SFR 0x10
180#define TI_RW_DATA_ADDR_IDATA 0x20
181#define TI_RW_DATA_ADDR_XDATA 0x30
182#define TI_RW_DATA_ADDR_CODE 0x40
183#define TI_RW_DATA_ADDR_GPIO 0x50
184#define TI_RW_DATA_ADDR_I2C 0x60
185#define TI_RW_DATA_ADDR_FLASH 0x70
186#define TI_RW_DATA_ADDR_DSP 0x80
187
188#define TI_RW_DATA_UNSPECIFIED 0x00
189#define TI_RW_DATA_BYTE 0x01
190#define TI_RW_DATA_WORD 0x02
191#define TI_RW_DATA_DOUBLE_WORD 0x04
192
193struct ti_write_data_bytes {
194 __u8 bAddrType;
195 __u8 bDataType;
196 __u8 bDataCounter;
197 __be16 wBaseAddrHi;
198 __be16 wBaseAddrLo;
199 __u8 bData[0];
200} __attribute__((packed));
201
202struct ti_read_data_request {
203 __u8 bAddrType;
204 __u8 bDataType;
205 __u8 bDataCounter;
206 __be16 wBaseAddrHi;
207 __be16 wBaseAddrLo;
208} __attribute__((packed));
209
210struct ti_read_data_bytes {
211 __u8 bCmdCode;
212 __u8 bModuleId;
213 __u8 bErrorCode;
214 __u8 bData[0];
215} __attribute__((packed));
216
217/* Interrupt struct */
218struct ti_interrupt {
219 __u8 bICode;
220 __u8 bIInfo;
221} __attribute__((packed));
222
223/* Interrupt codes */
224#define TI_GET_PORT_FROM_CODE(c) (((c) >> 4) - 3)
225#define TI_GET_FUNC_FROM_CODE(c) ((c) & 0x0f)
226#define TI_CODE_HARDWARE_ERROR 0xFF
227#define TI_CODE_DATA_ERROR 0x03
228#define TI_CODE_MODEM_STATUS 0x04
229
230/* Download firmware max packet size */
231#define TI_DOWNLOAD_MAX_PACKET_SIZE 64
232
233/* Firmware image header */
234struct ti_firmware_header {
235 __le16 wLength;
236 __u8 bCheckSum;
237} __attribute__((packed));
238
239/* UART addresses */
240#define TI_UART1_BASE_ADDR 0xFFA0 /* UART 1 base address */
241#define TI_UART2_BASE_ADDR 0xFFB0 /* UART 2 base address */
242#define TI_UART_OFFSET_LCR 0x0002 /* UART MCR register offset */
243#define TI_UART_OFFSET_MCR 0x0004 /* UART MCR register offset */
244
245#endif /* _TI_3410_5052_H_ */