Linux kernel mirror (for testing) git.kernel.org/pub/scm/linux/kernel/git/torvalds/linux.git
kernel os linux
1
fork

Configure Feed

Select the types of activity you want to include in your feed.

at v2.6.39-rc2 258 lines 7.1 kB view raw
1#ifndef CCISS_CMD_H 2#define CCISS_CMD_H 3 4#include <linux/cciss_defs.h> 5 6/* DEFINES */ 7#define CISS_VERSION "1.00" 8 9/* general boundary definitions */ 10#define MAXSGENTRIES 32 11#define CCISS_SG_CHAIN 0x80000000 12#define MAXREPLYQS 256 13 14/* Unit Attentions ASC's as defined for the MSA2012sa */ 15#define POWER_OR_RESET 0x29 16#define STATE_CHANGED 0x2a 17#define UNIT_ATTENTION_CLEARED 0x2f 18#define LUN_FAILED 0x3e 19#define REPORT_LUNS_CHANGED 0x3f 20 21/* Unit Attentions ASCQ's as defined for the MSA2012sa */ 22 23 /* These ASCQ's defined for ASC = POWER_OR_RESET */ 24#define POWER_ON_RESET 0x00 25#define POWER_ON_REBOOT 0x01 26#define SCSI_BUS_RESET 0x02 27#define MSA_TARGET_RESET 0x03 28#define CONTROLLER_FAILOVER 0x04 29#define TRANSCEIVER_SE 0x05 30#define TRANSCEIVER_LVD 0x06 31 32 /* These ASCQ's defined for ASC = STATE_CHANGED */ 33#define RESERVATION_PREEMPTED 0x03 34#define ASYM_ACCESS_CHANGED 0x06 35#define LUN_CAPACITY_CHANGED 0x09 36 37/* config space register offsets */ 38#define CFG_VENDORID 0x00 39#define CFG_DEVICEID 0x02 40#define CFG_I2OBAR 0x10 41#define CFG_MEM1BAR 0x14 42 43/* i2o space register offsets */ 44#define I2O_IBDB_SET 0x20 45#define I2O_IBDB_CLEAR 0x70 46#define I2O_INT_STATUS 0x30 47#define I2O_INT_MASK 0x34 48#define I2O_IBPOST_Q 0x40 49#define I2O_OBPOST_Q 0x44 50#define I2O_DMA1_CFG 0x214 51 52/* Configuration Table */ 53#define CFGTBL_ChangeReq 0x00000001l 54#define CFGTBL_AccCmds 0x00000001l 55#define DOORBELL_CTLR_RESET 0x00000004l 56 57#define CFGTBL_Trans_Simple 0x00000002l 58#define CFGTBL_Trans_Performant 0x00000004l 59#define CFGTBL_Trans_use_short_tags 0x20000000l 60 61#define CFGTBL_BusType_Ultra2 0x00000001l 62#define CFGTBL_BusType_Ultra3 0x00000002l 63#define CFGTBL_BusType_Fibre1G 0x00000100l 64#define CFGTBL_BusType_Fibre2G 0x00000200l 65typedef struct _vals32 66{ 67 __u32 lower; 68 __u32 upper; 69} vals32; 70 71typedef union _u64bit 72{ 73 vals32 val32; 74 __u64 val; 75} u64bit; 76 77/* Type defs used in the following structs */ 78#define QWORD vals32 79 80/* STRUCTURES */ 81#define CISS_MAX_PHYS_LUN 1024 82/* SCSI-3 Cmmands */ 83 84#pragma pack(1) 85 86#define CISS_INQUIRY 0x12 87/* Date returned */ 88typedef struct _InquiryData_struct 89{ 90 BYTE data_byte[36]; 91} InquiryData_struct; 92 93#define CISS_REPORT_LOG 0xc2 /* Report Logical LUNs */ 94#define CISS_REPORT_PHYS 0xc3 /* Report Physical LUNs */ 95/* Data returned */ 96typedef struct _ReportLUNdata_struct 97{ 98 BYTE LUNListLength[4]; 99 DWORD reserved; 100 BYTE LUN[CISS_MAX_LUN][8]; 101} ReportLunData_struct; 102 103#define CCISS_READ_CAPACITY 0x25 /* Read Capacity */ 104typedef struct _ReadCapdata_struct 105{ 106 BYTE total_size[4]; /* Total size in blocks */ 107 BYTE block_size[4]; /* Size of blocks in bytes */ 108} ReadCapdata_struct; 109 110#define CCISS_READ_CAPACITY_16 0x9e /* Read Capacity 16 */ 111 112/* service action to differentiate a 16 byte read capacity from 113 other commands that use the 0x9e SCSI op code */ 114 115#define CCISS_READ_CAPACITY_16_SERVICE_ACT 0x10 116 117typedef struct _ReadCapdata_struct_16 118{ 119 BYTE total_size[8]; /* Total size in blocks */ 120 BYTE block_size[4]; /* Size of blocks in bytes */ 121 BYTE prot_en:1; /* protection enable bit */ 122 BYTE rto_en:1; /* reference tag own enable bit */ 123 BYTE reserved:6; /* reserved bits */ 124 BYTE reserved2[18]; /* reserved bytes per spec */ 125} ReadCapdata_struct_16; 126 127/* Define the supported read/write commands for cciss based controllers */ 128 129#define CCISS_READ_10 0x28 /* Read(10) */ 130#define CCISS_WRITE_10 0x2a /* Write(10) */ 131#define CCISS_READ_16 0x88 /* Read(16) */ 132#define CCISS_WRITE_16 0x8a /* Write(16) */ 133 134/* Define the CDB lengths supported by cciss based controllers */ 135 136#define CDB_LEN10 10 137#define CDB_LEN16 16 138 139/* BMIC commands */ 140#define BMIC_READ 0x26 141#define BMIC_WRITE 0x27 142#define BMIC_CACHE_FLUSH 0xc2 143#define CCISS_CACHE_FLUSH 0x01 /* C2 was already being used by CCISS */ 144 145/* Command List Structure */ 146#define CTLR_LUNID "\0\0\0\0\0\0\0\0" 147 148typedef struct _CommandListHeader_struct { 149 BYTE ReplyQueue; 150 BYTE SGList; 151 HWORD SGTotal; 152 QWORD Tag; 153 LUNAddr_struct LUN; 154} CommandListHeader_struct; 155typedef struct _ErrDescriptor_struct { 156 QWORD Addr; 157 DWORD Len; 158} ErrDescriptor_struct; 159typedef struct _SGDescriptor_struct { 160 QWORD Addr; 161 DWORD Len; 162 DWORD Ext; 163} SGDescriptor_struct; 164 165/* Command types */ 166#define CMD_RWREQ 0x00 167#define CMD_IOCTL_PEND 0x01 168#define CMD_SCSI 0x03 169#define CMD_MSG_DONE 0x04 170#define CMD_MSG_TIMEOUT 0x05 171#define CMD_MSG_STALE 0xff 172 173/* This structure needs to be divisible by COMMANDLIST_ALIGNMENT 174 * because low bits of the address are used to to indicate that 175 * whether the tag contains an index or an address. PAD_32 and 176 * PAD_64 can be adjusted independently as needed for 32-bit 177 * and 64-bits systems. 178 */ 179#define COMMANDLIST_ALIGNMENT (32) 180#define IS_64_BIT ((sizeof(long) - 4)/4) 181#define IS_32_BIT (!IS_64_BIT) 182#define PAD_32 (0) 183#define PAD_64 (4) 184#define PADSIZE (IS_32_BIT * PAD_32 + IS_64_BIT * PAD_64) 185#define DIRECT_LOOKUP_BIT 0x10 186#define DIRECT_LOOKUP_SHIFT 5 187 188typedef struct _CommandList_struct { 189 CommandListHeader_struct Header; 190 RequestBlock_struct Request; 191 ErrDescriptor_struct ErrDesc; 192 SGDescriptor_struct SG[MAXSGENTRIES]; 193 /* information associated with the command */ 194 __u32 busaddr; /* physical address of this record */ 195 ErrorInfo_struct * err_info; /* pointer to the allocated mem */ 196 int ctlr; 197 int cmd_type; 198 long cmdindex; 199 struct list_head list; 200 struct request * rq; 201 struct completion *waiting; 202 int retry_count; 203 void * scsi_cmd; 204 char pad[PADSIZE]; 205} CommandList_struct; 206 207/* Configuration Table Structure */ 208typedef struct _HostWrite_struct { 209 DWORD TransportRequest; 210 DWORD Reserved; 211 DWORD CoalIntDelay; 212 DWORD CoalIntCount; 213} HostWrite_struct; 214 215typedef struct _CfgTable_struct { 216 BYTE Signature[4]; 217 DWORD SpecValence; 218#define SIMPLE_MODE 0x02 219#define PERFORMANT_MODE 0x04 220#define MEMQ_MODE 0x08 221 DWORD TransportSupport; 222 DWORD TransportActive; 223 HostWrite_struct HostWrite; 224 DWORD CmdsOutMax; 225 DWORD BusTypes; 226 DWORD TransMethodOffset; 227 BYTE ServerName[16]; 228 DWORD HeartBeat; 229 DWORD SCSI_Prefetch; 230 DWORD MaxSGElements; 231 DWORD MaxLogicalUnits; 232 DWORD MaxPhysicalDrives; 233 DWORD MaxPhysicalDrivesPerLogicalUnit; 234 DWORD MaxPerformantModeCommands; 235 u8 reserved[0x78 - 0x58]; 236 u32 misc_fw_support; /* offset 0x78 */ 237#define MISC_FW_DOORBELL_RESET (0x02) 238} CfgTable_struct; 239 240struct TransTable_struct { 241 u32 BlockFetch0; 242 u32 BlockFetch1; 243 u32 BlockFetch2; 244 u32 BlockFetch3; 245 u32 BlockFetch4; 246 u32 BlockFetch5; 247 u32 BlockFetch6; 248 u32 BlockFetch7; 249 u32 RepQSize; 250 u32 RepQCount; 251 u32 RepQCtrAddrLow32; 252 u32 RepQCtrAddrHigh32; 253 u32 RepQAddr0Low32; 254 u32 RepQAddr0High32; 255}; 256 257#pragma pack() 258#endif /* CCISS_CMD_H */