tjh.dev
Linux kernel mirror (for testing)
git.kernel.org/pub/scm/linux/kernel/git/torvalds/linux.git
kernel
os
linux
1/* stnic.c : A SH7750 specific part of driver for NS DP83902A ST-NIC.
2 *
3 * This file is subject to the terms and conditions of the GNU General Public
4 * License. See the file "COPYING" in the main directory of this archive
5 * for more details.
6 *
7 * Copyright (C) 1999 kaz Kojima
8 */
9
10#include <linux/config.h>
11#include <linux/module.h>
12#include <linux/kernel.h>
13#include <linux/errno.h>
14#include <linux/interrupt.h>
15#include <linux/ioport.h>
16#include <linux/netdevice.h>
17#include <linux/etherdevice.h>
18#include <linux/init.h>
19#include <linux/delay.h>
20
21#include <asm/system.h>
22#include <asm/io.h>
23#include <asm/se/se.h>
24#include <asm/machvec.h>
25#ifdef CONFIG_SH_STANDARD_BIOS
26#include <asm/sh_bios.h>
27#endif
28
29#include "8390.h"
30
31#define DRV_NAME "stnic"
32
33#define byte unsigned char
34#define half unsigned short
35#define word unsigned int
36#define vbyte volatile unsigned char
37#define vhalf volatile unsigned short
38#define vword volatile unsigned int
39
40#define STNIC_RUN 0x01 /* 1 == Run, 0 == reset. */
41
42#define START_PG 0 /* First page of TX buffer */
43#define STOP_PG 128 /* Last page +1 of RX ring */
44
45/* Alias */
46#define STNIC_CR E8390_CMD
47#define PG0_RSAR0 EN0_RSARLO
48#define PG0_RSAR1 EN0_RSARHI
49#define PG0_RBCR0 EN0_RCNTLO
50#define PG0_RBCR1 EN0_RCNTHI
51
52#define CR_RRD E8390_RREAD
53#define CR_RWR E8390_RWRITE
54#define CR_PG0 E8390_PAGE0
55#define CR_STA E8390_START
56#define CR_RDMA E8390_NODMA
57
58/* FIXME! YOU MUST SET YOUR OWN ETHER ADDRESS. */
59static byte stnic_eadr[6] =
60{0x00, 0xc0, 0x6e, 0x00, 0x00, 0x07};
61
62static struct net_device *stnic_dev;
63
64static int stnic_open (struct net_device *dev);
65static int stnic_close (struct net_device *dev);
66static void stnic_reset (struct net_device *dev);
67static void stnic_get_hdr (struct net_device *dev, struct e8390_pkt_hdr *hdr,
68 int ring_page);
69static void stnic_block_input (struct net_device *dev, int count,
70 struct sk_buff *skb , int ring_offset);
71static void stnic_block_output (struct net_device *dev, int count,
72 const unsigned char *buf, int start_page);
73
74static void stnic_init (struct net_device *dev);
75
76/* SH7750 specific read/write io. */
77static inline void
78STNIC_DELAY (void)
79{
80 vword trash;
81 trash = *(vword *) 0xa0000000;
82 trash = *(vword *) 0xa0000000;
83 trash = *(vword *) 0xa0000000;
84}
85
86static inline byte
87STNIC_READ (int reg)
88{
89 byte val;
90
91 val = (*(vhalf *) (PA_83902 + ((reg) << 1)) >> 8) & 0xff;
92 STNIC_DELAY ();
93 return val;
94}
95
96static inline void
97STNIC_WRITE (int reg, byte val)
98{
99 *(vhalf *) (PA_83902 + ((reg) << 1)) = ((half) (val) << 8);
100 STNIC_DELAY ();
101}
102
103static int __init stnic_probe(void)
104{
105 struct net_device *dev;
106 int i, err;
107
108 /* If we are not running on a SolutionEngine, give up now */
109 if (! MACH_SE)
110 return -ENODEV;
111
112 /* New style probing API */
113 dev = alloc_ei_netdev();
114 if (!dev)
115 return -ENOMEM;
116 SET_MODULE_OWNER(dev);
117
118#ifdef CONFIG_SH_STANDARD_BIOS
119 sh_bios_get_node_addr (stnic_eadr);
120#endif
121 for (i = 0; i < ETHER_ADDR_LEN; i++)
122 dev->dev_addr[i] = stnic_eadr[i];
123
124 /* Set the base address to point to the NIC, not the "real" base! */
125 dev->base_addr = 0x1000;
126 dev->irq = IRQ_STNIC;
127 dev->open = &stnic_open;
128 dev->stop = &stnic_close;
129#ifdef CONFIG_NET_POLL_CONTROLLER
130 dev->poll_controller = ei_poll;
131#endif
132
133 /* Snarf the interrupt now. There's no point in waiting since we cannot
134 share and the board will usually be enabled. */
135 err = request_irq (dev->irq, ei_interrupt, 0, DRV_NAME, dev);
136 if (err) {
137 printk (KERN_EMERG " unable to get IRQ %d.\n", dev->irq);
138 free_netdev(dev);
139 return err;
140 }
141
142 ei_status.name = dev->name;
143 ei_status.word16 = 1;
144#ifdef __LITTLE_ENDIAN__
145 ei_status.bigendian = 0;
146#else
147 ei_status.bigendian = 1;
148#endif
149 ei_status.tx_start_page = START_PG;
150 ei_status.rx_start_page = START_PG + TX_PAGES;
151 ei_status.stop_page = STOP_PG;
152
153 ei_status.reset_8390 = &stnic_reset;
154 ei_status.get_8390_hdr = &stnic_get_hdr;
155 ei_status.block_input = &stnic_block_input;
156 ei_status.block_output = &stnic_block_output;
157
158 stnic_init (dev);
159
160 err = register_netdev(dev);
161 if (err) {
162 free_irq(dev->irq, dev);
163 free_netdev(dev);
164 return err;
165 }
166 stnic_dev = dev;
167
168 printk (KERN_INFO "NS ST-NIC 83902A\n");
169
170 return 0;
171}
172
173static int
174stnic_open (struct net_device *dev)
175{
176#if 0
177 printk (KERN_DEBUG "stnic open\n");
178#endif
179 ei_open (dev);
180 return 0;
181}
182
183static int
184stnic_close (struct net_device *dev)
185{
186 ei_close (dev);
187 return 0;
188}
189
190static void
191stnic_reset (struct net_device *dev)
192{
193 *(vhalf *) PA_83902_RST = 0;
194 udelay (5);
195 if (ei_debug > 1)
196 printk (KERN_WARNING "8390 reset done (%ld).\n", jiffies);
197 *(vhalf *) PA_83902_RST = ~0;
198 udelay (5);
199}
200
201static void
202stnic_get_hdr (struct net_device *dev, struct e8390_pkt_hdr *hdr,
203 int ring_page)
204{
205 half buf[2];
206
207 STNIC_WRITE (PG0_RSAR0, 0);
208 STNIC_WRITE (PG0_RSAR1, ring_page);
209 STNIC_WRITE (PG0_RBCR0, 4);
210 STNIC_WRITE (PG0_RBCR1, 0);
211 STNIC_WRITE (STNIC_CR, CR_RRD | CR_PG0 | CR_STA);
212
213 buf[0] = *(vhalf *) PA_83902_IF;
214 STNIC_DELAY ();
215 buf[1] = *(vhalf *) PA_83902_IF;
216 STNIC_DELAY ();
217 hdr->next = buf[0] >> 8;
218 hdr->status = buf[0] & 0xff;
219#ifdef __LITTLE_ENDIAN__
220 hdr->count = buf[1];
221#else
222 hdr->count = ((buf[1] >> 8) & 0xff) | (buf[1] << 8);
223#endif
224
225 if (ei_debug > 1)
226 printk (KERN_DEBUG "ring %x status %02x next %02x count %04x.\n",
227 ring_page, hdr->status, hdr->next, hdr->count);
228
229 STNIC_WRITE (STNIC_CR, CR_RDMA | CR_PG0 | CR_STA);
230}
231
232/* Block input and output, similar to the Crynwr packet driver. If you are
233 porting to a new ethercard look at the packet driver source for hints.
234 The HP LAN doesn't use shared memory -- we put the packet
235 out through the "remote DMA" dataport. */
236
237static void
238stnic_block_input (struct net_device *dev, int length, struct sk_buff *skb,
239 int offset)
240{
241 char *buf = skb->data;
242 half val;
243
244 STNIC_WRITE (PG0_RSAR0, offset & 0xff);
245 STNIC_WRITE (PG0_RSAR1, offset >> 8);
246 STNIC_WRITE (PG0_RBCR0, length & 0xff);
247 STNIC_WRITE (PG0_RBCR1, length >> 8);
248 STNIC_WRITE (STNIC_CR, CR_RRD | CR_PG0 | CR_STA);
249
250 if (length & 1)
251 length++;
252
253 while (length > 0)
254 {
255 val = *(vhalf *) PA_83902_IF;
256#ifdef __LITTLE_ENDIAN__
257 *buf++ = val & 0xff;
258 *buf++ = val >> 8;
259#else
260 *buf++ = val >> 8;
261 *buf++ = val & 0xff;
262#endif
263 STNIC_DELAY ();
264 length -= sizeof (half);
265 }
266
267 STNIC_WRITE (STNIC_CR, CR_RDMA | CR_PG0 | CR_STA);
268}
269
270static void
271stnic_block_output (struct net_device *dev, int length,
272 const unsigned char *buf, int output_page)
273{
274 STNIC_WRITE (PG0_RBCR0, 1); /* Write non-zero value */
275 STNIC_WRITE (STNIC_CR, CR_RRD | CR_PG0 | CR_STA);
276 STNIC_DELAY ();
277
278 STNIC_WRITE (PG0_RBCR0, length & 0xff);
279 STNIC_WRITE (PG0_RBCR1, length >> 8);
280 STNIC_WRITE (PG0_RSAR0, 0);
281 STNIC_WRITE (PG0_RSAR1, output_page);
282 STNIC_WRITE (STNIC_CR, CR_RWR | CR_PG0 | CR_STA);
283
284 if (length & 1)
285 length++;
286
287 while (length > 0)
288 {
289#ifdef __LITTLE_ENDIAN__
290 *(vhalf *) PA_83902_IF = ((half) buf[1] << 8) | buf[0];
291#else
292 *(vhalf *) PA_83902_IF = ((half) buf[0] << 8) | buf[1];
293#endif
294 STNIC_DELAY ();
295 buf += sizeof (half);
296 length -= sizeof (half);
297 }
298
299 STNIC_WRITE (STNIC_CR, CR_RDMA | CR_PG0 | CR_STA);
300}
301
302/* This function resets the STNIC if something screws up. */
303static void
304stnic_init (struct net_device *dev)
305{
306 stnic_reset (dev);
307 NS8390_init (dev, 0);
308 return;
309}
310
311static void __exit stnic_cleanup(void)
312{
313 unregister_netdev(stnic_dev);
314 free_irq(stnic_dev->irq, stnic_dev);
315 free_netdev(stnic_dev);
316}
317
318module_init(stnic_probe);
319module_exit(stnic_cleanup);
320MODULE_LICENSE("GPL");